<var id="lrprb"></var>

    <listing id="lrprb"></listing>

      <address id="lrprb"><big id="lrprb"><progress id="lrprb"></progress></big></address>

        <form id="lrprb"><sub id="lrprb"></sub></form>

          <track id="lrprb"><sub id="lrprb"></sub></track>

          <noframes id="lrprb">

            <thead id="lrprb"></thead><ol id="lrprb"><font id="lrprb"><pre id="lrprb"></pre></font></ol>

              <track id="lrprb"></track><dfn id="lrprb"><address id="lrprb"></address></dfn>

                <video id="lrprb"><progress id="lrprb"><nobr id="lrprb"></nobr></progress></video>

                聯系電話:13292436688

                河北貝卡纖維制造有限公司
                電話:13292436688
                聯系人:劉淑賢
                地址:河北唐山玉田楊家套
                網址:www.www.tjejtrampet.com
                當前位置:鋼纖維使用攪拌的順序
                鋼纖維使用攪拌的順序
                [來源:http://www.www.tjejtrampet.com] [作者:不詳] [日期:21-03-08] [瀏覽次數:]

                1.在傳輸帶上,一般先遞入料斗的是干砂,石,按當時設計時的比例先遞入攪拌斗。 2.在干料中加入適量的鋼纖維(鋼纖維的加入量根據設計要求,詳見使用配比)。 3.當砂、石、鋼纖維全部倒入料斗后,就可以進行干拌(切記千萬不要加水),一般干攪一分鐘至 二分鐘即可。 4.再加水進行(適量水)進行混凝土攪拌(請注意水的摻量切勿過量,否則鋼纖維容易結團) 5.將拌和好的鋼纖維水泥混凝土裝車,就可以運到施工現場使用了。 6.鋪裝過程可以使用大型機械,也可以手工鋪裝,這與普通混凝土鋪裝相同。 7.鋪裝完畢后須用壓實機振動壓實,不留泡或砂眼,要保證混凝土的實在。 8.最后對混凝土表面進行平整,人工與機械均可。注意不要將鋼纖維露到表面來。 1. on the transmission belt, the dry sand and stone are generally handed in to the hopper first, and then the mixing bucket is first delivered to the design according to the proportion at that time. 2. add proper amount of steel fiber to the dry material (the amount of steel fiber is added according to the design requirements, see the use ratio). 3. when sand, stone and steel fibers are poured into the hopper, they can be dry mixed (remember not to add water). Generally stir dry for a minute to two minutes. 4. again add water (appropriate water) for concrete mixing (please pay attention to the amount of water do not overdose, otherwise steel fiber easy to cluster) 5. will be mixed with good steel fiber cement concrete loading, can be transported to the construction site to use. 6. the paving process can be done with large machinery or manual pavement, which is the same as ordinary concrete pavement. 7. after finishing, the compactor must be vibratory and compacted without leaving bubbles or sand holes. 8. finally, the concrete surface can be leveled, both manual and mechanical. Be careful not to expose the steel fiber to the surface.

                版權 ? 河北貝卡纖維制造有限公司 網址:www.www.tjejtrampet.com 尼龍輸送帶 河北立體車庫 防撞墻模具 大棚遮陽網 麻繩
                保定網站建設及優化保定遨游網絡公司

                  <var id="lrprb"></var>

                  <listing id="lrprb"></listing>

                    <address id="lrprb"><big id="lrprb"><progress id="lrprb"></progress></big></address>

                      <form id="lrprb"><sub id="lrprb"></sub></form>

                        <track id="lrprb"><sub id="lrprb"></sub></track>

                        <noframes id="lrprb">

                          <thead id="lrprb"></thead><ol id="lrprb"><font id="lrprb"><pre id="lrprb"></pre></font></ol>

                            <track id="lrprb"></track><dfn id="lrprb"><address id="lrprb"></address></dfn>

                              <video id="lrprb"><progress id="lrprb"><nobr id="lrprb"></nobr></progress></video>
                              妓女asianmovies孕妇_爱啪啪av导航_国产高跟黑色丝袜在线_极品丰满国模自慰